Kontron COMe-cSP2 Manuel d'utilisateur télécharger pdf (Page 9)

COMe-cSP2 / Introduction

2.2 Understanding COMe-cSP2 functionality

All Kontron COM Express® basic and compact modules contain two connectors; each of it has two rows. The primary

connector has two rows called Row A and Row B. The secondary connector has two rows called Row C and Row D. The

primary connector (Row A and Row B) feature the following legacy-free functionality:

» Ethernet

» Serial ATA (SATA)

» USB 2.0

» LVDS/VGA and dual display video

» Intel High Definition Audio (Azalia)

» LPC (low pin count) Bus

» PCIexpress

The secondary connector (Row C and Row D) provides support for the following buses and I/O:

» PCI Express

» PCI

» IDE

2.3 COM Express® Documentation

This product manual serves as one of three principal references for a COM Express® design. It documents the

specifications and features of COMe-cSP2. The other two references, which are available from your Kontron Support or

from PICMG®, include:

» The COM Express Specification defines the form factor, pinout, and signals. This document is available from

the PIGMG website by filling out the order form.

» The COM Express® Carrier Board Design Guide by PICMG serves as a general guide for baseboard design, with

a focus on maximum flexibility to accommodate a wide range of COM Express® modules.

Note: Some of the information contained within this product manual applies only to certain product revisions (CE:

xxx). If certain information applies to specific product revisions (CE: xxx) it will be stated. Please check the

product revision of your module to see if this information is applicable.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 108 109

Pas de commentaire

Kontron COMe-cSP2 Manuel d'utilisateur Page 9