Kontron COMe-cSP2 Manuel d'utilisateur télécharger pdf (Page 12)

COMe-cSP2 / Specification

Display Interfaces

» CRT: VGA is not supported my the US15W System Controller Hub

» Flat Panel: Single Channel LVDS 18/24 Bit, resolution up to 1366 x 768 (WXGA), no dithering.

» Digital Display: Only SDVO supported on SDVO/PEG Interface on connector CD with resolution up to FullHD

1920x1080.

Storage

» IDE: Primary IDE (Master/Slave) from the US15W SCH with UDMA 100/66/33 support

» SATA: 2x Serial ATA supporting up to 3.0 GBit/s transfer rate (SIL 3132 PCIe2SATA Bridge)

» SATA Features: Boot, RAID0, RAID1, NCQ, Staggered Spinup, Port Multiplier

Onboard devices:

» Ethernet: Intel® 82574L (Hartwell), 10/100/1000 Mbit Ethernet (Max TDP 0.727W)

Features: WakeOnLAN, PXE Lanboot, Time Sync Protocol Indicator, Jumbo Frames

» TPM: Infineon SLB9635TT1 Trusted Platform Module 1.2 onboard

» Watchdog: integrated in onboard CPLD, possible delay: 1s, 5s, 10s, 30s, 1min, 5min, 10min, 15min

» PCI: PCIe-to-PCI Bridge PLX Technology PEX8112 (0.4W typical, 32bit/33MHz PCI 3.0)

» PCIe Switch: 8 Port PCIe Switch PLX Technology PEX8509 (1.2W typical, PCIe Gen1 with 2.5Gb/s, Link

Power Management L0-L3, Device Power Management D0-D3hot)

» Optional: 4 Port PCIe Switch PEX8505 (without support for PCIe Lane #2-4 on COMe connector)

Additional Interfaces:

» LPC: Yes

» SMBus: Yes

» I2C: Fast I2C (from US15W SCH)

» GPIO: 8 GPIO, 4 GPI and 4 GPO

» SDIO: 1x onboard miniSD Card Socket (US15W SDIO port #0)

1x SDIO port shared with GPIO signals (US15W SDIO port #1)

SD Card Specification 1.1

SDIO boot supported

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 108 109

Pas de commentaire

Kontron COMe-cSP2 Manuel d'utilisateur Page 12