Kontron VMP1 with Netbootloader Manuel d'utilisateur télécharger pdf (Page 39)

VMP1 Functional Description

ID 26037, Rev. 01 Page 2 - 17® 2002 PEP Modular Computers GmbH

2.4.3.7 DEBUG Interface and Pinout

A JTAG/BDM interface is provided on the VMP1 for software

debugging. The pinout of this connector is in accordance

with the pinout of the most commonly used emulator probes.

Debug Connector Pinout

2.4.4 Digital Temperature Sensor (LM75)

The VMP1 also provides an onboard digital temperature sensor with a thermal watch-

dog functionality (National Semiconductor LM75). This has various uses including, for

example, calibration of the onboard RTC over a wider temperature range.



Note:

As shipped, only the Altera onboard logic may be detected by

means of the JTAG interface. If the JTAG interface requires to be

re-configured for software debugging, please contact Support at

PEP Modular Computers for assistance.

Table 2-6: Debug Interface Connector (CON10) Pinout

Signal Pin Number Pin Number Signal

TDO 1 2 NC

TDI 3 4 TRST#

NC 5 6 3.3V

TCK 7 8 NC

TMS 9 10 NC

SRESET# 11 12 NC

HRESET# 13 14 KEY (no pin)

CHKSTP#1516GND

216

115

JTAG

CON10

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 119 120

Pas de commentaire

Kontron VMP1 with Netbootloader Manuel d'utilisateur Page 39