Kontron NetBootLoader Manuel d'utilisateur télécharger pdf (Page 67)

ID 1022-8317, Rev. 2.0

Command SyntaxNetBootLoader

Page 59

DESCRIPTION: To set or display the parameters of an Ethernet port the command

NET is used.

Initially the CPU board does not have any valid Ethernet port

configurations, therefore, these interfaces are inoperable. The initial

configuration of the Ethernet ports must be done from the primary

serial interface using the command “net ... -f”.

Using the “-f” option forces a CRC to be performed and stored along

with the other configuration parameters in the serial EEPROM.

Once the configuration of an Ethernet port is done, it is available for

operation. Later changes to the parameters do not require the use of

the “-f” option to force a CRC. This is done automatically.

If the NET command is issued without any parameters, the current

parameter settings of all the Ethernet ports is displayed.

NET (AMC)

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 85 86

Pas de commentaire

Kontron NetBootLoader Manuel d'utilisateur Page 67