Kontron NSC2U IP Network Server Manuel d'utilisateur télécharger pdf (Page 118)

NSC2U Server—5

Kontron IP Network Server NSC2U

Product Guide, rev. 1.4 December 2009

118

5.6.2 Installing the Server Board Back into the Chassis

1. Set the replacement board into place (Figure 104, “A”), using caution to make sure

no cables are pinched under the board. Insert the rear edge of the board first, and

line up the I/O ports at the rear of the system.

2. When placing the board into the chassis, make certain that the board does not

catch on the fan alignment bracket (“B”). Note the that bracket must reside under

the insulator.

3. Make sure the standoff locations line up correctly and reinsert the six screws

removed previously. (“C”)

Figure 103. Removing the Server Board

TS000570

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 151 152

Pas de commentaire

Kontron NSC2U IP Network Server Manuel d'utilisateur Page 118