Kontron NSW1U IP Network Server Manuel d'utilisateur télécharger pdf (Page 79)

Kontron IP Network Server NSW1U

December 2009 Product Guide, rev. 1.4

Server Component Replacements—NSW1U Network Server

2. Remove the adhesive cover from the bottom of the insulator.

Place the insulator around the battery, lining up the hole with the riser card assembly hole. See

Figure 61.

5.6.2 Running Setup

3. If this is the last task you are performing, replace the riser card assembly, the processor air duct

and the top cover of the chassis. Reconnect all the external devices and plug in the power cord(s).

4. Run Setup to restore the configuration settings to the RTC. For more information, see Section 6.1,

“Using the BIOS Setup Utility” on page 80.

Figure 61. Attaching the Battery Insulator

TS000418

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 109 110

Pas de commentaire

Kontron NSW1U IP Network Server Manuel d'utilisateur Page 79