Kontron KBox A-101 Users Guide Manuel d'utilisateur télécharger pdf (Page 29)

9. Setting Up the KBox A-101 KBox A-101 – User’s Guide (Version 1.00)

9.2.2. Bracket for Cabinet Mounting

This bracket (Fig. 26) allow you to mount the KBox A-101 in a vertical orientation in a cabinet (e.g. industrial cabinet)

corresponding to the desired orientation.

The mounting of the KBox A-101 into a cabinet is permitted only in a vertical orientation. You may choose

which side should be facing up or down (two operating positions). The bracket must be mounted on the

rear of the KBox A-101, according to the desired operating position, so that the keyhole mounting slots of

the bracket should be located above the unit (see

Fig. 27 and Fig. 28). Please observe that by using of this

kind of bracket the interfaces (WLAN and GPIO) on the rear side of the KBox A-101 are not available!

Before mounting the cabinet bracket (Fig. 26) to the KBox A-101, you have to disassemble:

 the WLAN and GPIO modules and interface connectors if you have ordered the KBox A-101 equipped for

WLAN and GPIO functionality

 the cover protection plates of the WLAN and GPIO interface slots, if you have ordered a KBox A-101

without WLAN and GPIO function.

Please refer to the subsection 9.3.1 “Opening and Closing the KBox A-101”.

Fig. 26: Bracket for cabinet mounting

Fig. 27: KBox A-101 with assembled bracket for cabinet mounting

Fig. 28: Keyhole slot dimensions

www.kontron.com 27

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 48 49

Pas de commentaire

Kontron KBox A-101 Users Guide Manuel d'utilisateur Page 29