Kontron KTA70M-mITX Manuel d'utilisateur télécharger pdf (Page 9)

KTD-N0861-B Page 2 Installation

KTA70M/mITX Users Guide

Warning: Turn off PSU (Power Supply Unit) befor configuring the board and do not hot plug

power supply, otherwise components (RAM, LAN cards etc.) might get damaged.

Warning: When mounting the board to chassis etc. please notice that the board contains

components on both sides of the PCB which can easily be damaged if board is handled without

reasonable care. A damaged component can result in malfunction or no function at all.

2 Installation Procedure

2.1 Installing the Board

To get the board running, follow these steps. If the board shipped from KONTRON has already components

like RAM mounted, then relevant steps below can be skipped.

1. Turn off the PSU (Power Supply Unit)

2. Insert the DDR3 SODIMM 204pin module(s)

Be careful to push it in the slot(s) before locking the tabs.

3. Connecting Interfaces and PSU

Insert all external cables for hard disk, keyboard etc. A display/monitor must be connected in order to

be able change BIOS settings. Connect 12V +/-5% PSU to the board via one of the two types of 4-pin

power connectors (both located next to the Audio Jack stack connector).

4. Power Button

Turn on mains power to the PSU. If board doesn’t boot, then PWRBTN_IN must be toggled; this is done by

shorting pins 16 (PWRBTN_IN) and pin 18 (GND) on the FRONTPNL connector (see Connector

description), by use of a “normally open” switch etc.

5. BIOS Setup

Enter the BIOS setup by pressing the <Del> key during boot up. Enter Exit Menu and Load Optimal

Defaults. Refer to the “BIOS Configuration / Setup“ section of this manual for details on BIOS setup.

6. Mounting the board to chassis

When fixing the Motherboard on a chassis it is recommended using screws with integrated washer and a

diameter of ⋲7mm. Do not use washers with teeth, as they can damage the PCB and cause short circuits.

Note:

To clear all BIOS settings, including Password protection, activate “Clear CMOS” Jumper for ⋲10

sec (without power connected).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 87 88

Pas de commentaire

Kontron KTA70M-mITX Manuel d'utilisateur Page 9